SakeTami
makeshiftwings
makeshiftwings

patreon


1st of the month! Patreon work, reward fulfillment & finishing mini dorayakitty embroidery

The first of the month is always a busy day for me since i roll over my patreon to a new month of rewards! If you haven't read the post about March rewards, you can check it out here!
The patreon shop, which is accessible to $5 patrons and higher, has been updated with the clodsire pattern and the bacon&egg stickers. All non-ditto plushies that didnt sell are now in my public shop!
I also have fulfilled the first batch of ditto stickers and plush, with more going out tomorrow!
Finally after doing some accounting i wrapped up the face embroidery for the mini squish cat ITH patterns, which is a part of the pattern reward for March $5 tips & tutorials patrons and higher! These little guys still need the stabilizer washed off the embroidery but i wanted to show them to you guys anyway~
Have a good night!

1st of the month! Patreon work, reward fulfillment & finishing mini dorayakitty embroidery 1st of the month! Patreon work, reward fulfillment & finishing mini dorayakitty embroidery 1st of the month! Patreon work, reward fulfillment & finishing mini dorayakitty embroidery

Comments

We have ALL been there!!! Dont worry!

makeshiftwings

Thank you both!! The first time I used it I full on sprayed it with water without even ripping any off and it melted into the sherpa I was using 😭 I felt very silly!!

Dragon Pixies

I like using q-tips and a small cup of hot water!

Slothie Studios

nope! you want to remove as much as you can by hand and then wash away the tricky bits. i usually wet my finger or a cloth and rub the stabilizer until its gone, including on the spikey bits you're talking about. you dont want to wash away all of it because it can make the fabric hard and crusty after it dries. i usually never submerge my plush because unless you run it through a dryer which you generally dont want to do with handmade stuff it wont dry completely and can result in the stuffing getting moldy!

makeshiftwings

Do you really have to submerge the whole piece to rinse the stabilizer off?? I'm pretty new to using water soluble stuff & some of my pieces feel spiky where I ripped it off, but I'm afraid to give it the big dunk 😥

Dragon Pixies

Oh nooo it's soo cute! 😭😭😭 look at all that squish potential!

Dinogaby

Squeeze the child

BeetleMakes

Soooo cuteee!! 😍

Savannah


More Creators