D-O v1 instructions

I split the big files in my slicer to fit on the print bed, you should be able to do the same without much issue.

Jef Lepine

Go here: https://www.patreon.com/mrbaddeley/posts then scroll down to where it has drop downs for media, tier and month. Click tier and select all patrons. then scroll down to any of the files and shares posts.

I as well having a hard time finding all the files or trying to figure it out

Paul giovannucci

Filter the posts by ‘patreon’ and you’ll find a post which is called ‘files n shares’ which has the Patreon link.

Michael Baddeley

I'm new to Patreon and I can't figure out where to download either?

Jason Yap

Am I missing something? I cant see anywhere to download this? :(

Michel Bondo Hansen

I'd be interested in a 200 cut as well.

Mike

Now for the silly question, Is there any plans for a 200x200x180 cut of this? Most of it will print on the smaller printer, but the drive gear F, R and the Tyre area bit too big for my printer :-(

Ray Edgley

j'aimerais télécharger les fichiers mais ou dois je aller ?

titou creations

Very Nice model. Printed in a couple of days. I used a normal RC receiver and remote. Here is the test drive: https://youtu.be/aiu9ElEg-cA

C.PZO

Ok thank you very much

Hi, it’s 25mmx37mmx7mm :-D

Michael Baddeley

Hello everyone, I am hoping to tackle this project. I have already started building a BB8, but am low on funds so i wanted to start a D-0 to have something to present. I had a question about the "6805-2RS Bearings." What inside and outside diameter are they? I am finding a few different bearings with that name, but they have different diameters. thank You

Is there a specific BOM list for the bolts and other hardware? I'm can't get those things locally and would like to get all t he parts in 1 order, but I'm afraid even after going through the instructions that I'm going to miss something.

Scott Glinski

Found it... :D Thanks! I wish there's a list of screw sizes, seems like it's buried in the instruction.

FrogyDiak

Check the instructions, I’ve merger everything together into one and it does have virtually all the bits.

Michael Baddeley

Hello! Is there a Parts List for the D-O remote controller? I'm collecting all the electronics parts and although I found D-O Parts so far.pdf file but it doesn't have the parts for the controller except for Arduino Mega. The file DO v1 Wiring Diagram.pdf (Page 1) shows the parts but without the name.

FrogyDiak

Good stuff Thanks Michael. Hopefully can start to print in a few months.

Andrew Phillips

I have everything printed and going to paint next. I have most of the needed hardware. I went through the instructions to familiarize myself with them, any idea when the head section will be completed?