ThinAir3D

Click-Screw Fidget Now Available!

Added 2025-01-09 06:23:24 +0000 UTC

Hey everyone!

Here is a new fidget I've been fine-tuning, I call it the Click-Screw Fidget! Its a fairly simple model. There are two main pieces (one of which is comprised of two pieces itself), that create 5 satisfying clicks when they are screwed together.

It prints in about an hour on Bambu machines, using around 18g of filament.

I have attached print instructions and all STL's to this post, and have also uploaded them to the Drive Archives. There are two versions, one that can be used as a keychain and one without the keychain attachment.

Some goals for this design were for it to be keychain-sized, but also able to be played with using one or two hands. I've been tweaking and fine-tuning the threads for a little while now (longer than I'd like to admit). The major challenge was finding the right thread angle that would be satisfying to twist with two hands while still being satisfying to press up and down with one hand (think detonator).

As long as your printer can handle 0.40 clearances this should be a fairly quick and easy print.

As always, thank you all very much for all of the support! I hope you enjoy this design.