HQ Dungeon Tile 1 Preview
Added 2021-11-21 20:18:37 +0000 UTCThe tiles will be 1.25 with walls being .25. The walls will be on the tile, so making the outer room tiles 1.00. Everything fits well on each tile.
Each tile will be in two parts, the top is the stone texture (like in the pic) and the bottom will be the base with clip/magnet holes. Best would be to print the top in resin and bottoms with fdm.
Comments
I've just re-joined after quite some time away. Being honest, I had little interest in non-HQ stuff, or stuff that could be used in HQ, like some of the fantasy creatures etc, but with the release of the new HQ game from Hasbro, I started checking out HQ resources again and see that you have some grand plans...so I have rejoined. I have both FDM and Resin printers (Creality CR-6 SE and Phrozen Sonic 4K) and have just downloaded the above linked test file. As suggested, I will FDM print the bottom and resin print the top...I'll do the FDM piece now and the resin piece in the next few days and will provide feedback with pics... EDIT: Bummer, I just got the bottom going on the FDM printer and then got the top into Lychee to support it, and realised that it is too big for my build plate :(
Danny
2021-12-03 07:43:08 +0000 UTCYes, will be making everything.
James Boykin
2021-11-23 01:47:46 +0000 UTCWill you be doing tiles that “fit over/replace” board sections like in several of the Quests?
Oftkilted
2021-11-22 20:13:49 +0000 UTC
