SakeTami
chillichump
chillichump

patreon


Sneak peak at what's coming up!

It has been a mad few weeks for me. I have been travelling for work, and because of the weather in Oregon I was stuck there for a few more days than expected! Which is why I wasn't able to get a video out for this past Friday.

I thought I would give you a sneak peak of the progress so far with my plants, as well as another project I have been working on.







Firstly some good news, BOTH competition Poblanos seeds have germinated! The soil one took a week longer than the Hydro one. But both are doing well. I have the start of a couple of the Spaghetti peppers too.




I also started a new batch of seeds, just in case. The box on the top there with the screen is a little waterproof temperature sensor I built to keep track of the water temp.










I showed a picture to a friend of the project I'm working on and he assumed it was a bomb... It is in fact a controller I am building for my Hydro Ebb and Flood system. It has a a sensor to detect the light levels (the information will be used to optimise the flooding schedule...still working on the calculations for that). The 3 knobs are for adjusting the duration and interval for the pump, and light levels threshold. There will be a small relay controlling the pump, as well as an LCD for display.

I will be busy this weekend potting up and moving plants out to the small geeenhouse, and should have a video out on Monday if all goes to plan! How is your season going?

Sneak peak at what's coming up!

Comments

Thank you

This is the pin layout: <a href="https://i.imgur.com/2PdSiAd.jpg" rel="nofollow noopener" target="_blank">https://i.imgur.com/2PdSiAd.jpg</a> The center is live, so connect the positive to that, and check each of the other wires with gnd (if the attached doesn't help)

<a href="https://www.amazon.co.uk/gp/product/B002KTZJOQ/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&amp;psc=1" rel="nofollow noopener" target="_blank">https://www.amazon.co.uk/gp/product/B002KTZJOQ/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&amp;psc=1</a>

That sounds about right...but would need to see the fan to know for sure

Hi Shaun, I'm making a stir plate next the fan has 3 wires all black but I have seen on the web that pin 1 is Ground Pin 2 is positive and 3 is the sensor. I'm putting in a HALJIA CCM2 Adjustable Volt DC Motor Speed Controller so I'm guessing I put the ground wire in the negative output and the positive in the positive and disregard the sensor wire?

Hi Shaun, I went in through the door and put silicon round the wire to seal the hole it's working a treat ;-)

Have a look for a drain hole at the bottom of the fridge...you may get lucky!

Hi Shaun I put it all together and put 2 lamps in to test it and it worked! Now all I have to do is get the heater wire in the fridge without hitting the coolant lines I was thinking of going through the door

Apologies Dave, I am only just heading home from work now. Be careful with wiring it up especially since you are working with mains voltage. Let me know if you still need a hand and I will sort you out when I get home!

Hi Shaun, I got all the items listed on your video about making a ferminator I posted the question before they had arrived....I had a rare day off work and spent a few hours searching YT and there are loads of videos from the home brew channels on how to wire it all in, some were a bit "less safe" than I would have liked! But I have got the basics on how to do it ;-)

Hi Dave, sure...I will have a look when I get home. It is pretty straightforward though. Did you get the STC?

Hi Shaun do you have a wiring diagram for the control box of the ferminator? I've got all the bits just need to know where the wires go so I can get the "angry pixies" to do there thing Cheers

Hey Shaun, Your plants are looking very nice! I am glad the LED lighting is working out for you so far. I have one too, i use it when the plants are small, they seem to do ok. :-) Too bad you didnt make a trip up north to Vancouver whilst in Oregon! I still owe you that pint!


More Creators