Two-Shot 3D Printing To Get A Grip
Added 2018-12-07 02:07:21 +0000 UTCThis is my first try at doing a two shot printing process with my 3D printer and the results are very satisfying. I see a lot of potential for this technique. Enjoy!
Comments
the quest for knowledge is it's own reward.
2018-12-10 16:12:31 +0000 UTCI also did the calculations on paper, so yea. :-)
Fran Blanche
2018-12-08 15:42:25 +0000 UTCI think it is the kind of tool that you honestly have to need to justify the expense. Filament and upgrades add up too.
Fran Blanche
2018-12-08 15:41:00 +0000 UTCI wish there was a reasonably priced combined 3D printer, CNC mill, & laser cutter. Β£1000 is the going rate for such a device at the moment which is more than I wish to pay.
John Russell
2018-12-07 20:19:06 +0000 UTCA 3D printer is on my list of things to buy when I have the money!
Dr Andy Hill
2018-12-07 09:05:54 +0000 UTCCool stuff. Perhaps add a Frant before you post it on YouTube. π
Larry Taylor
2018-12-07 03:26:01 +0000 UTCI like the mixing of the old and new technologies.
John N Nelson
2018-12-07 02:45:42 +0000 UTC
