December Release - OSR2 Bearing Arms
Added 2021-12-23 23:10:50 +0000 UTCHi Guys,
This is my release for the month of December. It's the part files for a pair of arms and a support link for the OSR2 that use rod end bearings. I've been a bit more careful in the design of these because they take bending loads that the SR6 links don't, but they seem to work just great.
You will need 4x M4 male rod end bearings, and 8x M4 Nuts to use these parts.
I have also included the same 4mm spacer part that I included with the SR6 links. You will need to use three of these to get the right range of motion: one at each of the OSR2 receiver's attachment points. As I said with SR6, in future I intend to improve the part design to no longer need them.
Have a good Christmas! I'll see you soon.
Tempest
(The files are protected with the december password because of an ongoing Patreon security flaw. Check your email. As a $8 patron you should have received the password separately, but feel free to contact me if you have any trouble. The files are also available on my discord server.)
Comments
They’re actually counterbores and should be large enough for an M3 washer to sit in them. Countersunk screws could be done but would probably need a modification to the design.
TempestVR
2022-02-15 19:51:20 +0000 UTCI noticed that these seem to have countersunk holes for the servo mounting points - is that correct? Should we swap out for countersunk M3 screws over the socket head?
g90ak
2022-02-15 18:17:38 +0000 UTC
