TCode EXP32 v0.21b
Added 2021-08-01 00:17:22 +0000 UTC- Adding TCode v3.1 code (You can switch back to v2.0 in the web config. Requires restart)
- Adding validation to servo zeros (valid values are 1250-1750)
- Updating zeros does NOT require reboot anymore.
- Gave the config page a make over. (still needs some work)
- Fix issue where inverse stroke was actually wrong on OSR2. (Sorry, If you find your stroke inverted just toggle the inverse stroke setting)
- Adding Valve Servo 90 degree mode. For those like me who didn't buy a 180 degree servo.
- Made some settings hidden depending on Device mode/TCode version
Comments
Also this is not the latest 0.211 is https://www.patreon.com/posts/tcode-esp32-v0-54665233. Dont think it has anything to do with this issue just FYI. https://www.patreon.com/posts/tcode-esp32-v0-54665233
Khrull
2021-08-21 14:05:54 +0000 UTCYou can also check out what serial monitor in the Arduino IDE says on boot to get an Idea on what maybe going on. Youll need to set it up for esp32 first. https://randomnerdtutorials.com/installing-the-esp32-board-in-arduino-ide-windows-instructions/
Khrull
2021-08-21 14:03:50 +0000 UTCThis happens to some people and I have not figured out why yet. Are you using windows 10? Can you try with another device? There is known issues with iphones and the web interface but you should at least be able to see the ap mode network.
Khrull
2021-08-21 14:02:17 +0000 UTCTrying to get the device to move at all. I have successfully flashed the device, but can't seem to find the wifi network to access its settings.
Stephen Scott
2021-08-21 13:54:23 +0000 UTC
