🖌️New video tomorrow. My secrets for printing perfect resin bases
Added 2025-05-17 20:00:06 +0000 UTCThe first thing I think about when I have to print a base is that they tend to be quite large pieces.
That's why I almost always choose to print them in PLA.
But, of course... not all bases are the same.
When trying to print something very complex in PLA, you inevitably have to sacrifice quality. Not to mention the more complex elements, which simply don't turn out well.
So, in these cases, I turn to resin.
The quality is impressive, and every micro-detail is preserved.
But then the next problem arises...
Completely flat bases and resin printers don't get along at all.
I've seen dozens of posts with the same drama: warped bases, with support marks everywhere, poorly placed drainage holes, or even print failures.
Frustrating, right?
Well, let me tell you something: after much trial and error, I discovered a way to print resin bases with all the detail you want, without warping, and with a completely flat bottom base... without a single mark or hole.
Yes, it's possible. And tomorrow I'll show you everything in a video.
I'll share step-by-step instructions on how to achieve that perfect finish, no fuss.
This method took me many hours of trial and error, but now you can apply it right away and get professional results from the first try.
Don't miss tomorrow's video.
It'll change the way you print your bases forever.
Comments
Hahaha, with your subscription you'll receive over 100 hours of videos, not just this one. If you need any help, you can always write to me even if you're not a subscriber, and we'll see where the problem lies.
B Studios
2025-05-19 10:43:43 +0000 UTCFriend! 50/50! If you want, you can send me a message and we'll talk about what's going on with that issue.
B Studios
2025-05-19 10:40:36 +0000 UTCMan this flat base problem is a tough one.It’s like 50/50 succes rate for me.One thing im sure. 45 degree is the key.Im waiting for the full video.
Burak Ayçiçek
2025-05-17 20:28:12 +0000 UTCman i know your running a business but this should be a public video for the greater good of the community for solidarity lol I'm drunk its real hard to com up with plan on orientation when prepping to print a base lol . I'm a free member and have no rite to an opinion but its tempting lol to pull the trigger and become a full member just to see this video but i think the community will be very grateful .
beast32678
2025-05-17 20:09:49 +0000 UTC
